Hardy Process Solutions

Several of my HI 2151/20WC's will not retain the calibration or parameters if input power is removed. None of the units has a battery installed on the main board, although there is a provision on the board for mounting a battery. Why will some units retain the calibration and others not?

What is the easiest way to send a Tare command to the HI 1746WS?

What is the easiest method of sending the Tare command to the HI 1746WS?

Do you have a map for M0 and M1 files inside the HI 1746WS module?

Do you have a complete map for M0 and M1 files inside HI 1746WS module? I am specifically looking for information about the meaning for bits and words.

How do I zero my weight controller over RIO from ControlLogix?

I have a ControlLogix 5550 PLC and a HI 2151/20WC, HI 2151/30WC and a HI 2110WI Series Weight Controller connected to it via Remote I/O. I can get the weight back by moving a zero in the first and second word of the discrete output table. Now I need to zero out the unit before getting the weight. Can you tell me what bit to set in the second output word to zero the scale?

Base de connaissances

Catégories

What are the steps for setting up the Easy 8 module?

How can I receive firmware update notifications for my HI 6310 WP?

What status indications available for the HI 2080?

How do I verify my scale system is balanced?

What is averaging and how does it work?

How do I set up the relay set points on my HI 2151/30WC?

Why won't my HI 2151/20WC retain the calibration or parameters if power is removed?

What is the easiest way to send a Tare command to the HI 1746WS?

Do you have a map for M0 and M1 files inside the HI 1746WS module?

How do I zero my weight controller over RIO from ControlLogix?