Hardy Process Solutions

Why would my MSG instruction remain at enable without an error or a time out?

I have a new HI 1756-2WS module. When I do a MSG instruction to run a command, it will lock up indicating it is enabled, but it never goes to done or error. Why would the MSG instruction remain at enable without an error or a time out? Sometimes it seems that the MSG instruction would work for channel 1, but not for channel 0.

Are there sample programs for the HI 1746 WS module?

How can I receive firmware update notifications for my HI 1769-FC?

I am setting up a 3-leg weigh system for a conical bottom cylindrical tank. I...

I am setting up a 3-leg weigh system for a conical bottom cylindrical tank. I have reviewed the load cell placement documentation, and it presents good information for placement of load cells around the circumference of the tank. In general, is it better to place the load cells below the tank (CG of tank above load cells) or to have the tank suspended with the CG of the tank below the load cells?

How would I wire 8 load cells into a single system?

How would I wire 8 load cells into a single system? Do you have a diagram showing this arrangement?

Can the WS 100 program work with an Ethernet driver?

Can I use an Ethernet Driver to communicate to the SLC processor using the WS 100 configuration software?

What type of metal are the HI LPRC03 Weigh Module mounts made of?

I installed a Profibus option card and it is not recognized.

A customer has a standard HI4060 Rate Controller. He ordered a Profibus-DP card and installed it in the unit. The unit does not identify the Profibus-DP. what can they do?

How do I upgrade the firmware on my HI 6610 WPM?

How do I upgrade the firmware on my HI 6610 WPM in my HI 6600 system?

Base de connaissances

Catégories