My weight reading does not start at zero with an empty vessel or locks at a high weight level. My contractor said something about linear correction. What exactly is linear correction and what are some indications of a poor linear correction?
My weight reading is fine until I reach weights of 32,767 lbs. After this, it rolls over to a negative number. Why isn't my instrument reading correct above 32,767 lbs?
Can I calculate the expected Millivolt reading of my scale? I want to place a test weight on the scale and know what the expected signal Mv load cell output increase will be.
I have a communications problem between my controller and the PLC. The PLC weight reading is higher than the reading displayed on the front of the controller. What could be the problem?