Hardy Process Solutions

Results: 201 - 210 of 540

When should I perform an IT test on my weight controller?

When should I do the IT test on my weight controller? I understand that when an IT Test is in progress the outputs from the load cells are interrupted. Would this cause errors in the actual weight while my application is weighing?

How do I troubleshoot my HI 3000 series controller?

Do you have guidelines for troubleshooting my HI 3010, or my HI 3030?

Setting up HI 4000 series to ControlLogix via EIP

How do I setup my new HI 4050 or the HI 4060 to communicate to my Control Logix PLC over Ethernet IP?

Can I turn off WAVERSAVER®?

Can I turn off WAVERSAVER® in my Hardy controller?

How can I receive firmware update notifications for my HI 4060?

How can I receive firmware update notifications for my HI 3030?

Why is my HI 4050 weight drifting after I install the Remote I/O option?

My HI 4050 weight reading is stable until I installed the Remote I/O option. After installing the option I am seeing weight fluctuations around 3 in 10,000. Why would the RIO option affect the weight reading stability?

What does a flashing power light indicate on my HI 3000 series controller?

Can I perform mapping from the front panel?

Can I perform mapping from the front panel of my Hardy Instrument?

how do I read the net weight float value so I can get down to a tenth of a pound?

Using DeviceNet, I need to read the float value of the net weight so I can get down to a tenth of a pound (hundredths would be nice too.) When I map HFI4 to DFO0, I get 1112041062. But if I map HFI4 to DIO0, I get 50 (the weight of the weight I'm using.) How do I read the float value and get 50.10 like the Hardy screen says?

Base de connaissances

Catégories