You have no items in your shopping cart.

New HI6800 Weight Controller

Weight-based Application Control
HILPB - ADVANTAGE® Compression Load Point Weight Module Systems (44 to 450 lbs)

HILPB - ADVANTAGE® Compression Load Point Weight Module Systems (44 to 450 lbs)

The Hardy HI LPB ADVANTAGE® Series, sliding load point/weigh module system is designed for use on light to medium capacity vessels. With an IP rating of IP68/IP69K, and true hermetic sealing, these are accurate load cells for low capacity installations.

Complete Your System

Or call 858.278.2900 for assistance

Hermetic Load Point/Weigh Module Assembly Compression Low Range HI BBH06 Sensors: 44 - 450 lbs. (20 - 200kg)

The Hardy HI LPB ADVANTAGE® Series, sliding load point/weigh module system is designed for use on light to medium capacity vessels. Each weigh module consists of mounting hardware and HI BBH06 stainless steel mV/V and mV/V/ohm matched load sensor with true hermetic sealing, C2® Electronic Calibration capabilities, onboard electronic certs, a ¼ NPT conduit adapter, and ten feet of cable.

Each pre-assembled load point system provides lift-off protection and consists of three mount types specifically designed to eliminate the effects of unwanted forces to provide exceptionally accurate load cells. The assembly can be positioned 360 degrees in ninety-degree steps. A grounding strap and fixed color code wiring label are provided with each load cell HI BBH06 sensor. The mounting hardware is available in either stainless or zinc plated steel. The sensors have an IP rating of IP68/IP69K.

The HI LPB is available in the following standard capacities: 44 lbs, 110 lbs, 225 lbs, 450 lbs, and comes fully assembled with a shipping bracket for protection.

Hardy also offers Dummy load cells that have the same mounting and load introduction as the cell it replaces. These are used as intermediate placeholders in weighing systems that are being worked on (i.e. welding, painting, and moving vessels), and those that require input and output apparatuses in any given application. These are usually used in self-aligning load points that require dry runs of the system prior to complete operation.

Welding fixtures are temporary fixtures used during alignment and welding. Welding Fixtures have the same dimensions and bolting pattern as the load point being installed.

Rated Output

  • ES) 2±0.002mV/V

Non-Linearity

  • <±0.018 % R.O.

Hysteresis

  • <±0.025 % R.O.

Zero Balance

  • <±1.0 % R.O.

Creep @ 5 Min.

  • <±0.01 % R.O.

Temp Effect Output

  • <±0.0014 % R.O./C

Temp Effect Sensitivity

  • <±0.0007 % R.O./C

Input Resistance

  • 1050 to 1150 ohms

Output Resistance

  • 1000 ± 2 ohm

Insulation Resistance

  • >5000 Mohm

Excitation

  • 5 - 15 vdc

Safe Load Limit

  • 200 % Emax

Ultimate Load

  • 300 % Emax

Safe Side Load

  • 50 % Emax

Max Lift Off

  • 100 % Emax

Warranty

  • Two years

Specifications are subject to change without notice.

Mount

Capacity

Mount Finish

Model # - HILPB copy
Or call 858.278.2900 for assistance